The pasting method of non-woven wallpaper is slightly different from that of ordinary wallpaper. The following are the specific pasting steps and special precautions:

1. ‌Wall treatment‌

• Ensure that the wall is flat, dry, free of dust and oil stains. If there are cracks or unevenness, they need to be repaired with putty and polished smooth first.

• Apply a layer of base film (wallpaper specific primer) to enhance the adhesion of wallpaper and prevent moisture.

2. ‌Cutting wallpaper‌

• Cut the wallpaper according to the wall height and pattern splicing requirements, generally leaving a margin of 5-10cm.

• Pay attention to the alignment of patterns, especially for styles with obvious patterns.

3. ‌Glue application method‌

• ‌special featureThe adhesive for non-woven wallpaper only needs to be applied to the wall surface, not the back of the wallpaper (unlike PVC wallpaper).

• Use specialized wallpaper adhesive and apply it evenly on the wall to avoid missing or excessive thickness.

4. ‌Paste wallpaper‌

• Gently apply the trimmed wallpaper to the wall from top to bottom, use a scraper (or soft bristled brush) to level it from the middle to both sides, and remove any air bubbles.

• Pay attention to aligning the patterns to avoid misalignment.

5. ‌Edge trimming treatment‌

• Use a craft knife to cut off excess parts along the skirting board or ceiling edge, keeping the edges clean.

6. ‌Special precautions‌

• ‌Avoid pulling hardNon woven fabric material is relatively soft, and excessive stretching may cause deformation or uneven seams.

• ‌Rapid constructionThe glue dries quickly and needs to be applied in one go to avoid repeated tearing.

• ‌Yin corner treatmentOverlap 1-2cm at the corner of the wall to ensure complete coverage.

7. ‌Final Inspection ‌

• Check for bubbles or curled edges and promptly repair with a scraper.

The pasting method of non-woven wallpaper is relatively simple, but attention should be paid to details to ensure a beautiful and long-lasting effect.